AARP Hearing Center
Residential remodeling contractor (and article author) Vince Butler at home with his mother, Patricia.
Photo courtesy Vince Butler
I’ve been a professional remodeling contractor for more than 30 years and have extensive experience doing aging-in-place renovations and home modifications.
When my wife and I remodeled our home, we added an office above the garage. A few of the features we added were done "just in case" the space ever needed to become an apartment for one of our parents. That option became a reality after my father passed away and my mother moved in, adding us to the nation's growing ranks of multigenerational households.
The conversion from an office space to my mom's new residence was certainly easier due to the pre-planning for the original remodel. For instance, I included a full bath with a shower instead of just a half bath that's normally needed for an office. At the time, the additional cost of the shower was minimal compared with the difficulty and expense involved of adding a shower later.
I had also added a wet bar for coffee and refreshments. But in addition to installing the sink and a small refrigerator, I ran an electrical cable that was sized to accommodate a future kitchen range.
Another consideration was to ensure that we met the building code requirements for a bedroom, which includes having a smoke detector and proper emergency egress. These added features were unnecessary if the room was being exclusively used as an office. Including them in the project added very little to the initial cost. Modifying the space later, though, might have been prohibitively pricey.
The conversion from office to a comfortable and private apartment was completed in about three weeks — but all wasn’t perfect and without regrets. By creating a home within my home for my mother I learned how my thinking ahead worked well, and not well enough.
There are several simple solutions I could have included in the initial construction, and the challenge of later having to accommodate my mom as she recovered from surgery drove home a few more lessons, namely: The time to install "aging-friendly" features in a home is when it's being built or remodeled — regardless of the age of the current or potential residents. Waiting until something in particular is needed is often too late. When time is limited and costs are high, homeowners often rely on less effective and possibly less safe solutions.
A little planning and creative design now will pay off if the need arises. If it doesn't, the following features — many of which I should have incorporated into my project — will still add value for a future owner.
For The Entire House
1. Raise the Outlets. Lower the Switches
There is no height requirement for electrical outlets or switches in most homes in the U.S. In fact, outlets are typically placed at a height equal to the length of a hammer simply because it saves measuring time during construction. Ask to have your outlets raised to 18" above the floor so they're easier to reach while standing or from a seated position. Light switch boxes are generally set above 48". If you move the box below 48" it makes the switch easier to reach from a wheelchair, scooter or by a child.
2. Use Aging-Friendly Light Switches
Paddle-style switches are better than a traditional toggle switch since they can be easily operated with a finger, knuckle or even an elbow.
3. Over Light and Dim it Down
It's always better to install more lighting than you think you’ll need and include dimmers for control. Coming back later to correct a dark corner or work area is expensive and messy. LED lights provide excellent illumination without overtaxing the wiring circuits and are easily dimmable.
4. Use Wide Doorframes
Use doors that are ideally 36" wide. (The minimum width used should be at least 32".) You don't have to install the wider doors now, but if you frame for that possibility you'll preserve the space and locate switches, pipes and other obstructions clear of any future widening.
5. Select Aging-Friendly Hardware
When choosing door knobs, cabinet hardware and plumbing fixtures, select designs that can be comfortably used without excessive pinching, twisting or force. Consider whether a child or a person without full use of his hands or arms could successfully use the item.
For The Stairs
6. Double-Up On Handrails
Double handrails make staircases safer and easier to use.
Photo from The Center for Universal Design
Staircases should have a handrail on each side to provide additional support or to assist someone who has a strength imbalance due to age, injury or illness.
7. Wider is Better Than Narrow
Most residential staircases are 36" wide, but if a project includes a new staircase, 42" would be better. That width makes it easier for two people to use the stairs side-by-side and better accommodates a lift chair, if required. Also, a wider staircase is especially useful when moving furniture!
8. Deep is Better Than Shallow
If space allows, make the treads (the flat part of the step) a bit deeper and the risers a bit shorter. Even a small change can make the stairs safer and easier to use.
9. Put Power Nearby
Include an electrical outlet at the top and/or bottom of the stairs. That way, if you ever install a lift chair it can be plugged in and charged without having to use an unsightly and possibly hazardous extension cord. In the meantime, having an electrical outlet near the stairs is very handy when vacuuming.
10. Shine a Light on It
Building codes require that staircases have switches at the top and bottom. However, we don’t always use those lights when our hands are full or we don’t want to disturb sleepers in the bedrooms nearby. Motion-activated switches that turn lights on and off automatically are a helpful option.
In The Bathroom
11. Block the Bars
Wooden "blocking" installed before a wall is finished provides a secure location for installing grab bars and other wall fixtures, such as towel bars and hooks.
Photo courtesy Vince Butler
When a grab bar isn't securely mounted, it's more likely to become loose and fall off the wall. The best way to prevent this is before the walls are finished by installing horizontal wood "blocking" at the proper height for grab bars in the tub, shower and toilet areas. Installing such blocking is inexpensive and easy to do during construction but can be very costly and disruptive later. Tip: Before the drywall is installed, run a measuring tape from the floor up to the framing and take a picture to document exactly where the blocking has been placed. There are ways to install grab bars without blocking but nothing is more solid and secure than fastening directly to the wood framing.
12. Open and Close the Door
Doors are the number one obstacle to having a usable bathroom when someone requires assistance or is using a mobility aid. Sometimes an out-swing door works better for a bathroom than an in-swinging one. In other scenarios, a pocket door may be the better solution.
13. Cut-out the Curb
A shower is generally more usable and safer than a bathtub. Eliminate the typical step-over shower curb for a zero-step solution. If desired, the space can accommodate a frameless glass shower enclosure or, if needed, be converted into a fully-accessible shower for either a seated transfer or roll-in use.
14. Grab the Grab Bars Now
If the walls are blocked already, install the grab bars. People of all ages can benefit from having something to grab onto near the shower or tub. (I found the grab bars in my bathroom to be quite helpful while I was recovering from shoulder surgery.)
Kitchen Duty
15. Low, Medium and High
Various height kitchen countertops provide options for use by a child, a tall person and someone who prefers to sit rather than stand while preparing a meal.
Planning Ahead
A skilled construction or design professional can help make a home "aging friendly." Visit nahb.org/CAPS to find someone who has a Certified Aging-In-Place Specialist (CAPS) designation.
16. Put it Away
Provide storage options in locations that don’t require lifting, and include pull-out drawers and trays and other accessories to increase usability.
17. Pick Aging-Friendly Appliances
Consider the design of stoves, dishwashers and refrigerators to minimize or eliminate hazards such as reaching over a hot burner to adjust the controls. Evaluate the design for usability by people with varying abilities and locate the appliances to minimize lifting or bending. For instance, placing a microwave oven above the range is an example of not planning for the future.
18. Two Sinks are Better Than One
Consider installing a second sink with a pullout spray faucet near the cooking area. Doing so is handy for filling a pot with water for boiling — and then emptying that pot without having to carry it across the kitchen.
The Big Picture
19. Easy In, Easy Out
A large, "curbless," walk-in shower is useful for residents of all ages (and muddy dogs, too).
Photo courtesy Vince Butler
There should be at least one way to get into the home without having to use steps. Installing a zero-step entry into the house (and into a shower, as noted above and shown at right) solves two of the most challenging obstacles to creating an age-friendly home. If plans include adding a garage or new living space, consider options that will create an entry that can be used by someone using a wheelchair, pushing a baby stroller or dragging wheeled luggage.
20. Stack the Closets
If a home has multiple levels, locating the closets in the same location on each floor creates space for a future elevator shaft. It might sound extravagant, but more and more houses are including this feature and the cost is minimized when the space is already available. Also, installing an elevator is often an affordable option compared to the cost of selling a home and relocating. If an elevator isn't needed, the house has two very useful closets.
21. One-Level Living
In an ideal world, all multistory homes would contain a full bath on the first or entry floor as well as a bedroom or room that could be converted into a bedroom. When building a new residence or renovating one, the existence of these two rooms are key to a home being aging friendly.
Every feature I've described is easier and less expensive to include during a renovation or new construction project than years after the crew has finished the job and gone. Including these features in my home office would have helped a lot once the space became my mom's apartment. For instance, I did need to install a chairlift with a dedicated electrical outlet. I unfortunately built a standard staircase, so the tight clearance around the chair is a constant challenge.
However, most home renovation work happening today is driven entirely by the homeowner's current needs and wishes rather than possibilities for the future. Including aging-friendly features in a home when they're optional provides the freedom to make choices rather than having decisions made in urgency or by others.
Look at your home and the spaces in it. A den may become a first floor bedroom, permanently or during a convalescence. A playroom might evolve into an exercise room. You probably won’t anticipate all the future uses of your home, but the benefits of these improvements will be useful today and for many years.
Vince Butler is the owner of Butler Brothers, a residential construction and remodeling firm based in Northen Virginia. He is a Certified Aging-in-Place Specialist (as well as a CAPS instructor), Graduate Master Builder (GMB) and Graduate Master Remodeler (GBR).
Home Sweet Home
More "Aging Friendly" housing resources:
Page published February 2016
